Hi,
Again I'm boldly going where no man has gone before.
I'm using a table in browser mode with a checkbox column.
On change of the checkbox, the only possible code to use is "Exit with modification" (onChange).
(BTW, onChange is not the same as Exit with modification, so some confusion there)
All works fine, except that unfortunately this code is ran twice, which I find rather inefficient.
But they're not gonna catch me on this one, so I'm making my own check box column using an image.
I'm using the click on the image to toggle the check column.
First I doubt my code, but then I find that the click code is also fired twice, so the checkbox is unchanged in the end :hot:
I'm sending a page to support and for now I'm going to the third workaround: change the table into a looper (browser mode) and see what happens.
Just another day in the life of a WX developper. ;-)
Kind regards,
Piet
Again I'm boldly going where no man has gone before.
I'm using a table in browser mode with a checkbox column.
On change of the checkbox, the only possible code to use is "Exit with modification" (onChange).
(BTW, onChange is not the same as Exit with modification, so some confusion there)
All works fine, except that unfortunately this code is ran twice, which I find rather inefficient.
But they're not gonna catch me on this one, so I'm making my own check box column using an image.
I'm using the click on the image to toggle the check column.
First I doubt my code, but then I find that the click code is also fired twice, so the checkbox is unchanged in the end :hot:
I'm sending a page to support and for now I'm going to the third workaround: change the table into a looper (browser mode) and see what happens.
Just another day in the life of a WX developper. ;-)
Kind regards,
Piet